Conversion - Ecolab EcoAdd Instrucciones De Servicio

14.1

Conversion

Rotating the control unit
To allow the pump to be adjusted to the site conditions, it is possible to turn the control
unit (operating unit/upper part of the pump).
DANGER!
Risk of electric shock
Pay attention to disconnect the power supply immediately and to secure
against accidental switch-on!
1
Fig. 104: Turning the pump head
1.
Loosen the fastening screws on the control unit.
2.
Lift the control unit approx. 5 cm upwards.
3.
Turn the control unit in the desired direction and place it on the housing.
4.
Tighten the fastening screws on the control unit (operating unit/upper part of the
pump).
2
The screws are not secured against falling out.
Ensure that they are not lost.
Use only original screws.
Two cables that pass control signals to the pump are located between the
pump control unit and the bottom part of the pump.
Ensure that these do not become trapped during the conversion.
The blue pump housing contains a seal for the control unit. During
assembly, ensure that the seal is free of contamination to prevent leaks.
The tightening torque for the fastening screws on the control unit
is approx. 1 Nm. To prevent damage to the thread, we recommend
tightening the screws by hand.
Conversion, upgrade, repair
4
3
183 MAN046939 Rev. 6-10.2021