Ecolab EcoAdd Instrucciones De Servicio página 367

1.
On the operating screen, press the maintenance symbol ( ,
To access the maintenance mode, press and hold the displayed
maintenance signal for around 3 seconds.
2.
If an [Access code] is active
If you have activated the [Access code]
Ä Chapter 8.5 'Main menu' on page 63 .
3.
Cancel maintenance: Press the Cancel button
ð The query screen closes, maintenance mode is not started and the operating
screen is displayed.
4. Start maintenance: Press the OK button
ð The EcoAdd puts the motor and the diaphragm into the maintenance position.
5.
A prompt screen 'Maintenance: Switch off pump!' is displayed.
6.
Switch off the EcoAdd using the 'ON/OFF button'
power supply. Then reconnect the mains power and switch the pump on again.
7. Carry out the maintenance.
8.
As the [access code] is still activated
again.
9.
After switching the pump back on, a prompt screen 'Maintenance performed?' is
displayed.
10. Do not confirm the completion of maintenance: Press the Cancel button
11. The notification screen 'Maintenance not completed!' is displayed.
The internal counter for the maintenance work performed
Ä Chapter 8.10 'Operating data' on page 126 ) is not increased.
(
After confirming this notification screen, the operating screen (item 14) is displayed
and the EcoAdd is ready for operation.
12. Confirm completion of maintenance: Press the OK button
13. The notification screen 'Maintenance completed!' is displayed.
The internal counter for the maintenance work performed
Ä Chapter 8.10 'Operating data' on page 126 ) is increased.
(
After confirming this notification screen, the operating screen (item 14) is displayed
and the EcoAdd is ready for operation.
, you must now enter the [Access code].
, note the following:
.
.
, the [access code] must now be entered
163
Maintenance
or ).
and then disconnect from the
.
MAN046939 Rev. 6-10.2021
.