Maintenance; Replacing The Filter - Bluewater Spirit 300 Manual Del Usuario

Replacing the filter

It is important to pay attention to filter replacement, as the
filter's primary job is to protect the membrane. Check that the
container is not leaking after filter replacement, and perform
follow-up checks.
Replace the filter when:
the filter light flashes or lights
the water purifier emits a noise
the flow is reduced by half.
1. Check that the water purifier is in standby mode.
Press and hold in the service button, using a pen,
until the service light comes on (approx. 6 seconds).
Release the button. The lights on the faucet now
flashes rapidly for 15 seconds. This procedure will
prevent flushing from taking place during filter
replacement.
2. Open the front cover using the grip, as illustrated.
3. Lift the lock plate on the filter cover and unscrew the
container. Use the supplied filter spanner if neces-
sary. Remember that the container is full of water
and that it can overflow!

MAINTENANCE

4.
5.
6.
7.
8.
9.
10.
Filter replacement before indication:
If the filter is replaced before the light indicates that replace-
ment is necessary, reset in accordance with point 10. The only
difference is that the filter light first comes on and then go out.
8
Remove the old filter.
Wipe up any spillage on the base plate.
Clean the filter container with a brush and water.
Insert the new filter with the pin pointing up. Fill up
the container with water to the lowest thread.
Screw back the filter container. Tighten the filter con-
tainer until the locking plate clicks into the groove.
Do not tighten any more.
Close the front cover.
Reset the filter indicator by pressing in the filter but-
ton and keeping it pressed until the filter light goes
out (approx. 3 seconds). Use a pen.
The filter replacement is now complete and the
water purifier is ready to be used.