If The Water Purifier Is Not Working; Trouble-Shooting Table - Bluewater Spirit 300 Manual Del Usuario

IF THE WATER PURIFIER IS NOT WORKING

Trouble-shooting table

To protect the user and the water purifier from incorrect use,
there are built-in alarms which cause the purifier to give an
indication and stop. The table below gives probable causes of
warnings given by the water purifier.
SYMPTOM
ON light not lit.
Yellow light on the faucet flashing and filter light
flashing.
Yellow light on the faucet flashing and filter light
lit.
Yellow light on the faucet flashing and service
light flashing.
Yellow light on the faucet flashing and service
light lit.
Yellow and Green light on the faucet lit and serv-
ice light lit.
Noise from the water purifier.
Motor not starting.
Yellow or green light on the faucet lit.
Motor not starting.
Low flow from the faucet.
No flow from the faucet.
Dripping from the faucet during flushing.
Unpleasant smell.
If you are still having problems with your water purifier after having read through and tried the procedures described in the
trouble-shooting table, contact your dealer.
extinguished
CHECK/REMEDIAL ACTION
The water purifier is not receiving power.
- Is the plug connected?
Indicates that it is time for filter replacement.
- Change filter in accordance with «Replacing the filter».
Emergency stop due to filter not having been replaced.
- Change filter in accordance with «Replacing the filter».
Indication of deterioration in water quality.
- Contact your dealer for membrane replacement.
Emergency stop due to air in the system caused by filter
replacement.
- Pull out the plug and connect it again. Let the purifier go
throug the flush before starting production of pure water.
Emergency stop due to deterioration in water quality.
- Contact your dealer for membrane replacement.
The water quality measurement is not working.
- Contact your dealer for replacement.
The water purifier is not receiving sufficient water.
- Is the inlet pressure lower than 1.5 bar during operation?
- Is the grid blocked? — Clean the grid.
- Is the filter blocked? — Change filter.
The overflow protection has been triggered.
- Pull out the plug and wipe clean the base plate.
- If it is triggered again, call your dealer.
The water purifier is flushing.
- Wait for 5 minutes.
- Is the faucet cord connected?
- Is the membrane blocked?
- Descale the water purifier in accordance with «Descaling».
- Make sure the pure water hose is not jammed.
- Is the shut-off valve for the feed water open?
The hight distance between the faucet and the water puri-
fier is less than 500 mm.
- See «Installation».
Odour problems can be caused by micro-organisms in the
water because the water purifier has not been used for an
extended period (1 week or longer).
- Clean the water purifier in accordance with «Disinfection».
13
flashing lit