Disinfection - Bluewater Spirit 300 Manual Del Usuario

Disinfection

If the feed water has a high content of micro-organisms, the
water might develop an odour if the water purifier is not used
for an extended period of time (1 week). It is then necessary to
disinfect it. After the disinfection the filter has to be changed.
The disinfectant, sodium hypochlorite (concentration approx.
3.5%, odourless), can be purchased from supermarkets or
chemists.
The disinfectant must be kept out of reach
of children! Wash your hands after using it.
1. Check that the water purifier is in standby mode.
2. Press the service button, using a pen, until the serv-
ice light comes on. Release the button.The light on
the faucet now flashes rapidly for 15 seconds. This
prevents flushing from taking place during disinfec-
tion.
3. Disconnect the filter container in accordance with
«Replacing the filter», points 2 - 5. Remove the filter
and discard it (should not be saved).
4. Fill the container with 7 dl of lukewarm water and
pour in 1/4 dl of disinfectant. See fig. C.
5. Screw the filled container in place.
6. Start the water purifier and produce pure water for
30 seconds.
7. While production is in progress, pull out the plug as
shown in fig. D. Allow the water purifier to stand for
around 30 minutes.
8. Disconnect the container and insert a new filter into
it, in accordance with «Replacing the filter», points
7 - 8.
9. Connect the plug.
10. Close the front cover.
11. Flush the water purifier in accordance with «Flush-
ing».
Do not use the purified water until flushing is
complete.
The disinfection process is now finished. The water purifier is ready to be used.
MAINTENANCE
C
D
10