Maintenance; Replacing.the.filters - Bluewater RO400A Manual Del Usuario

rePlaCinG the filters
It is important to pay attention to filter replacement, as the filters' primary job is to protect the membrane. Check that the contain-
ers are not leaking after filter replacement, and perform follow-up checks.
When the light for filter I or II is lit, it is time to change the filter in question. First eliminate other possible fault cases, for further
information please refer to
RO600C/RO600CV: The filters are identical. When a filter needs changing, both filters should be replaced at the same time.
For illustrations , see FIG. .
rePlaCinG filter i
1. Ensure that the appliance has stopped and then pull
out the plug. Open the front cover situated in front of
the two pre-filters using the manoeuvre as illustrated
in FIG .
. Pull the filter containers out towards you as far as
possible.
. use the filter spanner to unscrew the container to the
left marked I. Remember that the container is full of
water and that it can overflow!
4. Remove the old filter.
5. Wipe up any water on the base plate.
6. Clean the filter container with a brush and water.
7. Insert the new filter with the label I pointing up.
Ensure that the sealing ring is in the filter container's
groove.
8. Screw the container into place using the filter span-
ner. Tighten the filter container so that the dot is
somewhere between the two outermost white lines.
9. Push the filter containers into the water purifier.
10. Close the front cover and connect the plug. The
water purifier flushes automatically.
The replacement of filter I is now complete and
the water purifier is ready to be used as normal.

maintenanCe

TROuBLESHOOTING TABLE
.
rePlaCinG filter ii
1. Replace filter II, situated in the container to the right,
by following steps 1-10 in
. Purified water production should have stopped and
the appliance should be connected to the wall socket.
To reset the appliance's integral counting mechanism
for filter replacement, hold the button (calibration)
depressed for approximately 7 seconds until the light
for filter II has gone out.
The replacement of filter II is now complete and
the water purifier is ready to be used as normal.
rePlaCinG filters i +ii (ro600C/ro600Cv)
To reduce pressure drop the flow through the filters in RO600C/
RO600CV are parallel and the two filters are identical. There-
fore, when changing filters, both filter I and II should be
replaced at the same time. Make sure that the correct filter for
RO600 is used.
Filter I or II is lit: Replace filter I + II by following
steps 1 -  in
EN5
REPLACING FILTER I
.
REPLACING FILTER II
.