Connecting The Water Purifier; Indicator Light - Bluewater Spirit 300 Manual Del Usuario

Connecting the water purifier

Before the water purifier is placed in its intended position,
remove the plug at the end of the reject water hose and the two
plugs in the connections on the purifier, see fig. G. Connect the
two hoses and the faucet cord to the appliance as shown in
fig. H.
Feed water
1. Screw the bent end of the feed water hose onto the
water purifier. Check that the seal is in place in the
connection. See fig. H no. 1.
2. Open the shut-off valve on the feed water and check
that there is no leakage at the feed water hose.
Pure water
The pure water is routed via the pure water hose to the faucet
installed on the sink unit.
Connect the pure water hose from the pure water
faucet to the water purifier. Push the hose into the
bottom position, up to the mark (approx. 19 mm).
See fig. H no. 2.
Reject water
The reject water hose has already been connected to the water
purifier on delivery. The other end of the hose is connected to
the waste water pipe.

Indicator light

Connect the cable from the faucet indicator light, as
shown in fig. H no. 3, and place the water purifier in
the intended position.
Electrical connection
Connect the plug to the earthed wall socket as shown
in fig. I.
The water purifier starts and flushes for 90 seconds.
Flushing is performed every time the plug is con-
nected.
Do not drink the water until the flushing proce-
dure under «Flushing» has been completed.
INSTALLATION
G
H
I
18
2
1
3