Installation; Unpacking; Positioning The Water Purifier; Installing The Pure Water Faucet - Bluewater Spirit 300 Manual Del Usuario

Unpacking

If the appliance has been damaged during transporta-
tion, you should immediately notify the company
responsible for delivering it.
Carefully lift out the water purifier by taking hold of
the plastic bag and the rear handgrip. The appliance
can be damaged if it is lifted in any other way.
Check the purifier for any signs of damage and check
that no accessories are missing. Any damage, faults
or missing parts should be notified to the supplier.
Do not leave the packaging material lying around so
that children can play with it.
Remove the hose, see fig. A.

Positioning the water purifier

The water purifier must be installed under the sink unit and the
following points should be observed:
The purifier is installed upright, without support, on
a horizontal surface that can take the load.
The installation space should be close to cold water
supply, drainage and an earthed electrical supply.
It should be easy to inspect the control panel.
It should be possible to open the front cover so that
the filter container can be accessed.
The water purifier should be installed with a 2 cm
gap to any adjacent fittings or walls to ensure good
ventilation around the appliance.
Connections can be routed in any direction from
the connection point; make sure no connections are
crushed or damaged. The dimensions of the area
required for the water purifier are specified in fig. B.

Installing the pure water faucet

The pure water faucet is supplied complete with a pure water
hose. The faucet can be raised and lowered and can be turned in
either direction. If the hose has to be cut, use a sharp knife e.g.
a carpet knife, so that a flat, smooth and circular cut surface is
achieved, see fig. C. This is essential in order for the connec-
tion to be watertight.
If the distance between the faucet's highest point
and the water purifier's highest point is less than 500
mm, water can drip from the faucet during flushing.
See fig. B.
1. Mark the position on the sink unit where the pure
water faucet is to sit. Make sure there is room on the
underside for the hose and the faucet fittings.
2. Drill a hole with a diameter Ø 20 mm.
3. Install the pure water faucet on the sink unit as
shown in fig. D1. Maximum unit thickness is 40 mm.
Adjust the height of the faucet to the desired position
and secure it with the black nut.
Make sure that the cable to the faucet does not
get jammed during installation. See fig. D2.

INSTALLATION

A
B
C
D1
16
1
D2
2