Flushing; Moving The Water Purifier - Bluewater Spirit 300 Manual Del Usuario

Flushing

Flushing should take place when the water purifier:
is new and has never been used before
is reinstalled after having been stored/protected
against freezing
has been cleaned, in order to rinse out the detergent
has been fitted with a new membrane.
Do not use the pure water until flushing is
complete.
First check that:
the shut-off valve on the feed water is open
the connection for the feed water is watertight
the reject water outlet and pure water connections
are watertight
the filter container is properly tightened.
Check that there is no leakage from the connections during
flushing. In the event of leakage, pull out the plug and fix the
leak. Connect the plug and perform flushing again as described
below.
1. Check that the water purifier is in standby mode.
2. Press the service button, using a pen, until
service and filter lights come on (approx. 15 sec-
onds). The lights on the faucet now flashes rapidly.
3. Release the button. The flushing procedure is now
performed and takes 25 minutes. Water will be puri-
fied at the end of the procedure.
This water must not be used.
When the flushing procedure is complete, the lights on the
faucet goes out. The water purifier is now ready to be used.
INSTALLATION

Moving the water purifier

If you move the purifier from one place to another, you should
remember the following points:
Close the shut-off valve for the feed water before
removing the feed water hose.
Pull out the plug.
Always transport the appliance upright.
Install in accordance with the installation instruc-
tions.
If the water purifier will not be used for four months or more,
or if it is to be disconnected from the water and electricity for
several days, it should be put into storage. See «Storage».
both the
19