Storage - Bluewater Spirit 300 Manual Del Usuario

Storage

The water purifier should be put into storage if:
it is going to be disconnected from water and elec-
tricity for an extended period (1 week or more).
it is not going to be used to produce purified water
for a period of 4 months or longer.
Preserving agents can be ordered from your dealer, see «Con-
sumables».
The preserving agent must be kept out of reach of
children! Wash your hands after using it.
1. Check that the water purifier is in standby mode.
2. Close the shut-off valve on the feed water connec-
tion.
3. Disconnect the feed water hose from the shut-off
valve.
4. Unscrew the filter container in accordance with «Re-
placing the filter», points 2 - 5. Remove the filter and
discard it (should not be saved).
5. Put the filter container back in accordance with «Re-
placing the filter», points 8 - 9.
6. Mix 2 litres of preserving agent and 2 litres of water
in a bucket.
7. Insert the feed water hose in the mixture, making
sure that the mouth of the hose is constantly below
the surface level of the liquid, see fig. E.
8. Start producing pure water. The water purifier now
draws the mixture into it. Stop the production of pure
water once all the liquid has been fed into the water
purifier. Note! The noise produced by the water puri-
fier changes during the first few seconds.
9. Disconnect the feed water and pure water hose from
the water purifier.
10. Pull out the plug.
The water purifier is put into storage and can be
kept in this way without the risk of freezing.
On reinstallation, the water purifier should:
stand somewhere where the temperature is above +5°
C for at least 48 hours.
be supplied with a new filter, see «Replacing the
filter».
be flushed in order to wash out the preserving agent,
in accordance with «Flushing».
Don't forget to insert a new filter in the water
purifier.
MAINTENANCE
E
11