Water Production; Leak Protection System - Bluewater SPIRIT Manual Del Propietário

Water production

Figure 5. Water production on/off
Automatic flush
An automatic flush will be performed if one of the conditions below are fulfilled:
1
2
3
Figure 6. Automatic flushing
Pos Description
1 Flush after drawing water. Production cycles shorter than 60 seconds are added together, and flush takes place when total drawing
time exceeds 60 seconds.
2 Flush after maximum operation time 15 minutes. Next production cycle can be started immediately after completed flush..
3 Water purifier in standby mode. Spirit is connected to water and power and It is more than 6 hours since the last flush.

Leak protection system

A sensor at the bottom of the water purifier senses water leaks. If there is a leak, the feed water supply is stopped. The water
purifier cannot be started again until the leak has been repaired.
Owner's manual
+
20 s
15 min
6 h
+
30 s
300
300Cp 2.5 min
08
= 60 s
10 s
4.5 min