Tabla de contenido
Idiomas disponibles
Idiomas disponibles
6. Maintenance
4.12- Speed of the drums
The working speed of the drums is determined by the combination of the gears
used in the transmission.
The rotation synchronism between the drums and the feeding drums generates
an ideal crop processing flow, guaranteeing the cut quality and avoiding overload
problems that can, for example, cause the safety pins to break.
At the top of each drum there is a gearbox through which, by changing a pair
of gears, you can change the speed of the drums.
In general:
Higher drum speed is used for crops with little volume and lower speed for
more bulky crops.
DRUMS
SPEED
Lower
Intermediate
Higher
The harvester leaves the factory with
the drums set at the 'lowest' speed.
Remove the two bolts (D);
1.
Remove the cover (E) from the cutter set
2.
box;
Place the pair of gears according to the
3.
table above.
Replace the cover (B) and secure it with
4.
the four bolts.
Repeat the adjustment on the two drums.
5.
IMPORTANT!
Keep the same speed on both drums.
72
GEARS
A
B
Z 16
Z 78
Z 26
Z 68
Z 33
Z 61
Instructions Manual
A
B
D
A
B
E
Capítulos
Tabla de contenido
