Special Cases; Working Environments; Automatic Position Search (Rpa) - Corghi EM 9550 Plus Manual De Uso

the machine indicates it by temporarily display-
ing the "E 6" message. The procedure can now
be repeated.

Special Cases

- The "OUT 2" message can be displayed at the
end of the first spin. In this case it is advisable
to exit the programme by pressing the key:
the values of the weights necessary
for balancing the wheel are displayed. The
execution of the programme is interrupted,
thus not achieving the moderate improvement
of the end results. By pressing the
the optimisation procedure can be continued.
- At the end of the first spin the instruction
that the tyre is to be mounted on the rim in
the reverse direction may appear. If the user
does not wish to reverse the direction or this
is not possible, press the
machine will provide the instructions to com-
plete the programme without reversal.
- If a different working environment is recalled
between one OPT programme phase and the
next, when the working environment within
which the user was working with the OPT func-
tion is recalled, execution restarts from the
point where it was interrupted.
WORKING
ENVIRONMENTS
This wheel balancer allows three operators to
work at the same time thanks to three different

working environments.

Proceed as follows to recall a working environ-
ment:
- Press the
gramme menu;
- Use the
cursor;
- Select the
68
button: the
button to access the pro-
buttons to move the
programme;
EM 9550 Plus - EM 9550 C Plus - Operator's manual
- Press the
erator. The number of the operator required
is displayed in the LDC display
status line;
- Press the
and exit the programme menu. The machine
then activates the parameters previously saved
in that specific working environment.
The parameters which remain saved for every
working environment are:
- balancing mode; dynamic, alu x, motorcycle,
key
etc.;
- wheel dimensions; distance, diameter and
width or those relating to the active alu pro-
gramme;
- last step of the optimisation procedure (OPT).
The machine's general settings remain the same
for all working environments: grams/ounces,
sensitivity x1/x5, threshold, etc...
AUTOMATIC POSITION
SEARCH (RPA)
When the automatic position search programme
is activated, the machine stops the wheel in the
position for application of the inner side weight
at the end of every balancing spin; if it is equal
to zero, the wheel is stopped in the position for
application on the outer side.
Press the
ond side position with the guard raised.
Proceed as follows to deactivate the automatic
position search programme:
- Press the
gramme menu;
- Use the
cursor;
- Select the
- Press the
button to select a new op-
button to confirm selection
button to search for the sec-
button to access the pro-
buttons to move the
programme;
button to change the pro-