Troubleshooting Tips - GE ZEK938 Manual Del Propietário

Before You Call For Service...
Wall Oven
Trouble-
shooting tips
42
PROBLEM POSSIBLE CAUSE
OVEN DOOR WILL
NOT OPEN AFTER
A CLEAN CYCLE
OVEN NOT CLEAN
AFTER A CLEAN
CYCLE
"LOCK"
FLASHES IN
THE DISPLAY
LOCKED LIGHT
IS ON WHEN YOU
WANT TO COOK
CONTROL SIGNALS
AFTER ENTERING
COOKING TIME OR
DELAY START
"F-- AND A NUMBER
OR LETTER" FLASH
IN THE DISPLAY
DISPLAY GOES
BLANK
* The (wen is too hot. Allow the (wen to cool below locking temperature.
@
@
Oven controls improperl), set. See the Usir_g"the ,%_Cleanir_g" Over_ section.
Oven was heavily soiled. Clean up heavy spillovers before starting the
clean cycle. Heavily soiled ovens may need to self clean again or for a
longer period of time.
* The self:clean cycle has been selected but the door is not closed.
Close the oven door
* The (wen door is locked because the temperature inside die (wen has
not dropped below the locking mmpemmre. Press the CLEAR/OFF
pad. Allow the oven to cool
* You fbrgot to enter a bake temperature or cleaning dine. Press die
BAKE pad and desired temperature or the SELF CLEAN STD/LOW
pad and desired clean time.
* You have a flmcfion error code. Press die CLEAR/OFF pad. Allow file
oven to cool for one hour Put the oven back into operation.
* Disconnect N1 power to tlle oven for 30 seconds and dlen reconnect
power If the flmcfion error code repeats, ca/1 for se_Mce.
A fllse in your home may be blown or die circtfit breaker tripped.
Replace the fuse or reset the circtfit breaker
The clock is in the black-out mode. See the Over_ ConOol, Clock and
7_m,'r section.
@
DISPLAY FLASHES * Power fidlure. Reset file clock.
UNABLE TO GET * Oven control pads were not pressed properly. The BAKE and the
THE DISPLAY TO BROIL HIGH/LOW pads must be pressed at the sane time and held
SHOW "SF" fbr 3 seconds.
"PROBE" APPEARS * This is reminding you to enter a probe mmpemmre after plugging in
IN THE DISPLAY the probe. Enmr a probe mmpemmre.
POWER OUTAGE, * Power outage or surge. Reset the the clock, ff the oven was in use, you
CLOCK FLASHES must reset it by pressing the CLEAR/OFF pad, setting the clock and
resetting any cooldng flmcfion.
STEAM FROM * When using the convection feature, it is norton to see steam coming out
THE VENT of tlle oven vent. As the number of rocks or amount of food being cooked
increases, the amount of visible smam will incre_kse.
"BURNING" OR * This is normal in a new oven and will disappear in time. To speed the
"OILY" ODOR process, set a self:clean cycle for a minimum of 3 ]lours. See the Usir_g"the
EMITTING FROM Se_:Cleanir_g"Over_ section.
THE VENT
STRONG ODOR * This is mmporau: An odor flom the insulation around the inside of the
oven is nomlN for the first fe.w times the oven is used.
FAN NOISE * A cooling
tim or a convection tim (depending on die flmcfion you are
using) may automatically mrn on. This is normal. The cooling fan will
mrn on to cool inmma/parts. It may mn for up to 1-1/2 hours in 30"
models and up to 2 horns in 27" models after the oven is turned offi
The convection tim will cycle on and off until the flmcfion is over or
the door is opened.