Storz Thermoflator Manual De Instrucciones página 65

57
Anhang
Hinweise zur elektromagnetischen
Verträglichkeit (EMV)
Guidance and manufacturer's declaration – electromagnetic immunity –
Thermo ator ® model 26 4320 20-1 is intended for use in the electromagnetic environment speci ed below.
The customer or user of the Thermo ator
Immunity test IEC 60601 test level
3 V
Conducted RF
IEC 61000-4-6
150 kHz to 80 MHz
3 V/m
Radiated RF
IEC 61000-4-3
80 MHz to 2.5 GHz
Note 1: At 80 MHz and 800 MHz, the higher frequency range applies.
Note 2: These guidelines may not apply in all situations. The propagation of electromagnetic quantities is affected by absorptions and re ections of
buildings, objects and persons.
a Field strengths from xed transmitters, such as base stations for radio [cellular/cordless] telephones and land mobile radios, amateur radio, AM and
FM radio broadcast and TV broadcast cannot be predicted theoretically with accuracy. To assess the electromagnetic environment due to xed RF
transmitters, an electromagnetic site survey should be considered. If the measured eld strength in the location in which the unit is used exceeds
the applicable RF compliance level above, the unit should be observed to verify normal operation. If abnormal performance is observed, additional
measures may be necessary, such as reorienting or relocating the unit.
b
Over the frequency range 150 kHz to 80 MHz, eld strengths should be less than 3 V/m.
Appendix
Electromagnetic Compatibility
(EMC) Information
Table 4
for equipment and systems that are not life-supporting
® model 26 4320 20-1 should ensure that it is used in such an environment.
Compliance level
rms
3 V
rms
3 V/m
Anexo
Indicaciones sobre compatibilidad
electromagnética (CEM)
Electromagnetic environment – guidance
Portable and mobile RF communications equipment should be used
no closer to any part of the Thermo ator ®
including cables, than the recommended separation distance calcu-
lated from the equation applicable to the frequency of the transmitter.
Recommended separation distance:
[ ]
= 3 5 . 3 /
150 kHz to 80 MHz
[ ]
= 3 5 . 3 /
80 MHz to 800 MHz
[ ]
= 7 3 /
800 MHz to 2.5 GHz
Where P is the maximum output power rating of the transmitter in
watts [W] according to the transmitter manufacturer and d is the
recommended separation in meters [m].
Field strengths from xed RF transmitters, as determined by an
electromagnetic site survey a , should be less than the compliance
level in each frequency range b .
Interference may occur in the vicinity of equipment marked with
the following symbol:
model 26 4320 20-1,