3M Bair Hugger 36000 Instrucciones De Uso página 4

Instructions for use Instructions for use
1. 1. Ensure the power cord is connected to the back of the control Ensure the power cord is connected to the back of the control
unit and the power cord is plugged into an appropriate outlet. If unit and the power cord is plugged into an appropriate outlet. If
desired, ensure the provided monitor cable is connected to the desired, ensure the provided monitor cable is connected to the
back of the control unit and to the YSI-400 type input on the back of the control unit and to the YSI-400 type input on the
patient monitor. patient monitor.
2. 2. Use an alcohol wipe to clean and disinfect the patient's Use an alcohol wipe to clean and disinfect the patient's
forehead above the orbital ridge. Allow the patient's forehead to forehead above the orbital ridge. Allow the patient's forehead to
completely dry. completely dry.
3. 3. Connect the sensor to the sensor cable connector. Ensure the Connect the sensor to the sensor cable connector. Ensure the
sensor tab is properly connected and is fully inserted into the sensor tab is properly connected and is fully inserted into the
sensor cable connector (Figure 1). sensor cable connector (Figure 1).
sensor tab sensor tab
connector connector
Figure 1: Connect the Bair Hugger temperature sensor Figure 1: Connect the Bair Hugger temperature sensor
to the sensor cable to the sensor cable
4. 4. Remove backing liners on the sensor to expose adhesive Remove backing liners on the sensor to expose adhesive
(Figure 2). (Figure 2).
Figure 2: Remove the backing liners Figure 2: Remove the backing liners
4
3M™ Bair Hugger™ Temperature Monitoring Sensor Model 36000 3M™ Bair Hugger™ Temperature Monitoring Sensor Model 36000
5. 5. Position the sensor cable away from the patient's face and Position the sensor cable away from the patient's face and
apply the sensor to the patient's forehead above the orbital apply the sensor to the patient's forehead above the orbital
ridge (Figure 3). ridge (Figure 3).
Figure 3: Apply the SpotOn temperature sensor to the Figure 3: Apply the SpotOn temperature sensor to the
patient's forehead patient's forehead
6. 6. Gently press the edge of the sensor to ensure good adhesion Gently press the edge of the sensor to ensure good adhesion
with the skin. with the skin.
Optional: Support the sensor cable with the provided sensor Optional: Support the sensor cable with the provided sensor
cable clip. cable clip.
7. 7. The control unit will sense patient attachment after The control unit will sense patient attachment after
several seconds. several seconds.
8. 8. The patient's temperature will display on the patient monitor The patient's temperature will display on the patient monitor
once system equilibrium is reached. once system equilibrium is reached.
Removing the sensor Removing the sensor
1. 1. Disconnect the sensor cable from the sensor. Disconnect the Disconnect the sensor cable from the sensor. Disconnect the
sensor cable clip from the bed or sheet, if used. sensor cable clip from the bed or sheet, if used.
2. 2. Starting at the edge of the sensor, gently remove the sensor from Starting at the edge of the sensor, gently remove the sensor from
the patient (Figure 4). the patient (Figure 4).
sensor tab sensor tab
Figure 4: Remove the sensor Figure 4: Remove the sensor
Note: Do not use the sensor tab to remove the sensor from Note: Do not use the sensor tab to remove the sensor from
the patient (Figure 4). the patient (Figure 4).
Note: If needed, use an alcohol swab along the edge of Note: If needed, use an alcohol swab along the edge of
the sensor to help remove the sensor from the patient. the sensor to help remove the sensor from the patient.
3. 3. Discard the sensor and clean the sensor cable Discard the sensor and clean the sensor cable
according to institutional protocol. according to institutional protocol.
34-8719-2524-3 34-8719-2524-3
5