Idiomas disponibles
Idiomas disponibles
ASSEMBLY AHEAD STEM
To assemble the ahead stem you will need the
following tools.
(The tools are not part of the scope of delivery.)
• 5 mm and 4 mm Hex key
1. After rearranging the spacers, fit the ahead cap
again, align the handlebars to be straight in the
direction of travel and set the play of the control
bearing correctly. To do this, use the setting screw
in the ahead cap
ASSEMBLY BRAKE
OPENING AND CLOSING THE
V-BRAKE
1
1. Take the loose end of the brake cable and insert
the wedge into the predefined recess on the brake
handle.
GB
1
Correct setting: The handlebars must be easy to turn
without play in the control bearing.
2. Then, carefully pull the outer cover of the brake
cable to engage the end stop into the adjustment
screw of the brake handle.
When assembling the brake cable, please make
sure that the knurled screw of the brake cable is
situated straight in the holder of the front light. Oth-
erwise, the brakes cannot be assembled correctly.
2
2. Now tighten up the steerer tube clamping screws
of the stem with the correct torque.
The torque for the clamping of the stem on the steer-
er tube shaft: 5-6 Nm. Make sure that the stem is
firmly mounted to the steerer tube and cannot rotate.
1
2
3
3. Open and close the V-brake.
Press the brake arms together with one hand (1).
Insert the brake cable guide tube into the fixation
or release it from the fixation. The V-brake is now
2
2
1
open or closed (2).
19
