Dometic Marine Climate System MCS10 Instrucciones De Montaje página 26

Installation
 The seawater system should be installed
– with an upward incline from the speed scoop and seacock (1),
– through the strainer (3),
– to the inlet of the pump (4) and
– then up to the inlet of the air conditioning unit's condenser coil (5).
 The discharge from the air conditioning unit (5) should run to the sea-
water outlet thru-hull fitting (6) which should be located where it can
be visually checked for water flow and as close as practicable to the
waterline to reduce noise.
 Ensure the hose runs uphill from speed scoop to strainer (3), pump (4)
and air conditioning unit (5).
 Avoid loops, high spots or the use of 90° elbows with seawater hose.
 The air conditioning unit (5) should be installed as low as possible, but
never in the bilge or engine room areas (such as under a V-berth,
dinette seat or bottom of a locker).
 Ensure proper spacing around unit.
 Ensure that the selected location is sealed from direct access to bilge
and/or engine room vapors.
 Mount the unit (5) on a firm, level, horizontal surface.
 Double clamp all hose connections with stainless steel clamps,
reversing the clamps.
 Secure all threaded connections with threaded-sealing tape.
 Tighten one and a half turns beyond hand tight.
!
WARNING!
 Do not tighten the threaded connections too firmly. Otherwise the
threaded sealing tape may stretch and cause cracks to form within
hours or days.
 Before you start up the boat, check for any leaks. If you are unsure
of how to proceed, contact a qualified ship's mechanic. Otherwise
there is a danger of the boat sinking. This can result in death or injury
to persons.
26
MCS5, MCS10, MCS15
EN