Important Safety Rules; Fire-Fighting - Nussbaum TC 410 Manual De Instrucciones

(1*/,6+ ‡ ,QVWUXFWLRQV PDQXDO
FOLLOW THESE STEPS:
1) Remove the valve stem.
2) Clip the valve onto the inflator chuck making sure it is properly connected.
3) Make a last check to be certain that tyre and rim diameter correspond.
4) Check to be certain that rim and beads are sufficiently lubricated. If necessary
lubricate some more.
5) Press the pedal (Fig. M/1) down to start inflation.
6) Release frequently the inflating pedal to check pressure on the manometer (1, Fig.
M/2). Introduce more air little by little untill the correct pressure is reached.
N.B.: If you over inflate the tyre, hold the deflate button (2, Fig. M/2) until the cor-
rect pressure is reached. Release the button to check pressure on the manometer.

IMPORTANT SAFETY RULES!

1- Only specially trained personnel are allowed to perform these operations.
2- Do not allow others to operate or be near the tyre changer.
3- Do not mount tyre on rims if you cannot check that their diameters correspond.
4- Check to make sure the rim and the tyre have the same diameter.
5- Check to make sure the rim and the tyre are not damaged.
6- Seat beads and inflate tyres with short bursts of air checking the pressure frequently on the gauge.
7- NEVER exceed 3.5 bar (50 PSI) during bead seating operation.
IMPORTANT! If a higher tyre inflation pressure is required, remove the wheel from the tyre changer and continue the inflation procedure
with the wheel inside a special protection cage (commercially available).
8- After bead seating operation, NEVER exceed the maximum inflation pressure given by the tyre manufacturer.
9- ALWAYS keep hands and entire body back from inflating tyre.
WARNING!
If this machine catches fire, only use powder extinguishers or, alternatively, CO
flames.

11. FIRE-FIGHTING

35
M/1
1
2
M/2
extinguishers to put out the
2
TC 410