Removing The Post Fixing Bracket; Installing The Stroke Limiter (Optional) - Nussbaum TC 410 Manual De Instrucciones

(1*/,6+ ‡ ,QVWUXFWLRQV PDQXDO
1) Press the pedal (7, Fig. E) to move the horizontal arm (11, Fig. E) to the retracted position.
2) Use a screwdriver to undo the 4 self-tapping
screws (1, Fig. D/1) and remove the casing (2,
Fig. D/1).
3) Undo the screw (3, Fig. D2) and remove the
bracket (4, Fig. D/2).
4) Remove the casing, then press the pedal (7, Fig.
E) again to return the arm to the rest position.

6.7 INSTALLING THE STROKE LIMITER (OPTIONAL)

The optional stroke limiter is required for bead breaking on RUN FLAT, LOW PROFILE
and UHP tyres.
The STROKE LIMITER kit (Fig. D/3) comprises:
1) Bead breaking limiter
2) Adjuster pin
3) Bead breaking arm mounting pin
4) Shim
5) Fixing screws
6) Grease pot holder spacer bracket
7) Plastic strip
If the kit has not already been preinstalled on the tyre changer, to install it correctly
proceed as follows:
1) Use a size CH 10 spanner to unscrew the screws of the grease pot holder (1, Fig. D/4)
and mounting pin (2, Fig. D/4).
2) With the aid of the plastic strip supplied with the kit, release the spring from its seat
on the bead breaker arm (see Fig. D/5).
3) Remove the mounting pin and extract the bead breaker arm from the support, taking
care to recover the shim fitted between the support and the arm.
4) Fit the limiter on the bead breaker arm (see Fig. D/6).
5) Fit the bead breaker arm into the slots on the support.
6.6 REMOVING THE POST FIXING BRACKET
2
N.B.: Take care to fit the two shims
correctly; they must be mounted as
shown in Fig. D/7:
- between the support and the bead
breaker arm
- between the bead breaker arm and the stroke limiter
6) Align the holes in the various parts to allow insertion of the NEW
in the kit (see Fig. D/8).
D/6
7) Secure the fixing pin with the 2 screws removed earlier.
1
D/1
3
25
4
1
5
2
4
fixing pin, supplied
3
D/2
7
6
D/3
1
2
D/4
D/5
TC 410