Tabla de contenido
PROBLEM - CAUSE - SOLUTION
PROBLEM
CAUSE
Milk type not suitable for this prepa-
ration.
Milk dispensing spout dirty or clogged
by milk from previous dispensing.
Not enough milk in the tank.
One or more components of the milk
dispensing spout kit are dirty or clogged
by milk from previous dispensing.
The machine does not dis-
The milk tank dispensing spout is not
pense frothed milk.
correctly inserted into the milk tank lid.
The milk dispensing spout is not cor-
rectly inserted in the machine.
The dispensing spout is not correctly
inserted into the milk tank lid.
The milk kit is not correctly assembled. Make sure that all the components have been correctly assembled (refer to the CLEANING AND MAINTENANCE chapter).
The milk tank is not correctly attached
to the machine.
The 3 milk-based bevera-
The milk kit is not inserted or not cor-
ge icons do not light up.
rectly inserted.
SOLUTION
Use cold whole milk.
Wash the milk dispensing circuit.
Fill the milk tank up to the MIN level.
Wash the milk dispensing spout components using dish soap or in the dishwasher according to the instructions provided
in the "Dishwasher Suitability" chapter. Rinse thoroughly.
Make sure that it is correctly inserted into the hole on the milk tank lid by prying on the tab on the back of the spout.
Make sure to insert the milk dispensing spout until it locks into place.
Make sure that it is fully inserted into the hole on the milk tank lid.
Make sure to attach the milk tank to the machine until it locks into place.
Insert the milk kit in the machine until it locks into place.
EN
IT
Persistence of
the problem
Contact an
authorised
service centre.
41
Tabla de contenido
