To Install Mower - TRAPP 48L22AH0x8A Manual De Instrucciones

6. On one side of the mower, disconnect
suspension arm (A) from chassis and rear
lift link (C) from rear brackets (D); remove
retainer springs and washers.
7. On the other side of the mower, disconnect
suspension arm and rear lift link.
Caution!
Once rear lift links are disconnected, the
attachment lift lever will behave like a spring.
Hold it tight when changing position.

To install mower

Be sure the tractor is on level ground and set parking
brake.
1. Lower lift lever to its lowest position.
Caution!
The attachment lift lever behaves like a spring.
Hold it tight, and slowly move it to its lowest
position.
128
8. On the right-hand side, disconnect antisway
bar (S) from rear brackets (D); remove retainer
spring and washer, and pull mower in your
direction until bar fits into the hole on the
support.
9. Turn tractor steering wheel fully to the left.
10. Remove mower through right-hand side of
tractor.
2. Turn steering wheel fully to the left, and place
mower and deflector shield to right side of
tractor.
Run the belt forward and check if its course
 
is adequate on all the pulley grooves of the
brushcutter.
Note:
Check whether mower suspension arms (A)
are facing the front before placing mower
under tractor.
www.trapp.com.br