To Drive The Tractor Off Skid; Check Tire Pressure; Check Deck Levelness; Check For Proper Position Of All Belts - TRAPP 48L22AH0x8A Manual De Instrucciones

3. Place freewheel control in free wheeling
position to disengage transmission (See "How
to transport the tractor" in the Operation
section of this manual).
4. Roll tractor forward off skid.
5. Remove straps holding deflector shield up
against tractor.

To drive the tractor off skid

(see the Operation section for location and
function of controls)
1. Check engine oil level and fill fuel tank with
gasoline.
2. Place freewheel control in "transmission
engaged" position. (see "How to transport
the tractor" in the Operation section of this
manual).
3. Sit on seat in operating position, depress
clutch/brake pedal and set the parking brake.
4. Place motion control lever in neutral (N)
position.
5. Raise attachment lift lever to its highest
position.
6. Remove the key from the package and start
the engine (see "How to start the engine"
in the Operation section of this manual). With
the engine running, move the manual throttle
to idle position.
7. Release the parking brake.
8. Slowly move the motion control lever forward
and slowly drive tractor off skid.
9. Apply brake to stop tractor, set parking brake
and place motion control lever in neutral
position.
10. Turn ignition key to "STOP" position.
Continue with the instructions that follow.
110
Caution!
The belt stretching shaft is spring loaded. Hold
the shaft firmly and engage slowly.
Raise the implement height lever up to the
 
highest position.
If necessary, before operating the
 
brushcutter, adjust the guide wheels as
shown in the owner's/operator's manual.
Check the adjustments of the guide
wheels, the level of the platform and of
the rake.

Check tire pressure

The tires on your tractor were overinflated at the
factory for shipping purposes. Correct tire pressure
is important for best cutting performance.
Reduce tire pressure to PSI shown in the tires
 
themselves.

Check deck levelness

For best cutting results, mower housing should be
properly leveled. See "To level mower" in the
Service and Adjustments section of this manual.

Check for proper position of all belts

See the figures shown for replacing motion and
mower blade drive belts in the Service and
Adjustments section of this manual. Verify that the
belts are routed correctly.

Check brake system

After you learn how to operate your tractor, check
to see that the brake is properly adjusted. See "To
check the brake", in the Service and Adjustments
section of this manual.
www.trapp.com.br