Tabla de contenido
Idiomas disponibles
Idiomas disponibles
www.trapp.com.br
To use throttle control (D)
Always operate engine at full speed.
Operating engine at less than full throttle
reduces efficiency.
Full throttle offers the best mower
performance.
To use choke control (N)
Use choke control whenever you are starting a
cold engine. Do not use it to start a warm engine.
To engage choke control, pull knob out.
Slowly push knob in to disengage.
To move forward and backward
The direction and the speed of movement is
controlled by the motion control lever (J).
1. Start tractor with motion control lever in
neutral (N) position.
2. Release the parking brake.
3. Slowly move the motion control lever to the
position desired.
To adjust mower cutting height
The cutting height is controlled by the attachment
lift lever (A).
Place the attachment lift lever in the groove
corresponding to the cutting height you desire.
Move indicator (T) to that cutting height as a
reminder for next time.
The cutting height range is approximately 3.8
and 10.2 cm. The heights are measured from
the ground to the blade tip with the engine
not running. Those heights are approximate
and may vary depending on soil conditions,
grass height and type of grass being mowed.
The average lawn shall be cut to
approximately 6.3 cm during the cold season,
and to over 7.6 cm during hot months.
For healthier lawns, mow often and after
moderate growth.
For best cutting performance, grass over 15.2
cm in height shall be mowed twice. Make the
first cut relatively high; the second to desired
height.
To adjust gauge wheels
Gauge wheels are properly adjusted when they
are slightly off the ground, when mower is at the
desired cutting height in operation position. So,
the gauge wheels then keep the deck in proper
position to help prevent scalping in different
terrain conditions.
Note:
Adjust gauge wheels with tractor on a flat
level surface.
115
Capítulos
Tabla de contenido
Solución de problemas
