Tabla de contenido
Idiomas disponibles
Idiomas disponibles
52
(5)
(3)
(5)
(2)
(4)
7. Tighten the rear axle nut.
TORQUE: 93 N.m (9.3 kgf.m; 68 lbf.ft)
8. Tighten the adjusting nuts lightly, and then tighten
the lock nuts by holding the adjusting nuts with an
open end wrench.
9. Recheck the drive chain slack. Rear brake pedal
free play is affected when repositioning the rear
wheel to adjust drive chain slack. Check the rear
brake pedal free play and adjust as necessary
(page 19).
WARNING
If a torque wrench is not used for installation, see
your authorized Honda dealer as soon as possible to
check for proper assembly. Otherwise brake
effectiveness may be reduced.
(1) Rear axle nut
(2) Lock nut
(3) Adjusting nut
(4) Index mark
(5) Rear edge of
adjusting slot
(4)
(1)
Lubrication and Cleaning
Lubricate every 1,000 km (600 miles) or sooner if the
chain appears dry. Steam cleaning, high-pressure
washers and certain solvents can damage the chain
O-rings. Clean the outer surface of the chain with
kerosene. Wipe dry and lubricate only with SAE 90
transmission oil. Commercial spray-type lubricants may
contain solvents which could damage the rubber
O-rings.
NOTE
Do not apply lubricant in excess. Besides aiding in the
accumulation of dust, sand and dirt on the chain,
increasing its wear, the lubricant will be sprayed on
the motorcycle due to chain movement.
Owner's Manual
Capítulos
Tabla de contenido
