Phcbi MCO-50AIC Instrucciones De Operación página 18

INSTALLATION
5. Earth the incubator.
Earth the incubator during installation to prevent electric shock. If there is no earth wire at the location,
consult with qualified service personnel.
Notes:
• When an earth must be installed
If an earthed 3-pole outlet is not available, then an earth must be installed. Consult with qualified service
personnel.
• Installing an earth fault circuit breaker
If you must use the incubator in a moist or humid location, then it is recommended that an earth fault circuit
breaker be installed in the power supply circuit (i.e., the power supply at the incubator). Have the circuit
breaker installed by qualified service personnel.
6. In case of double stack or triple stack
For stacking the incubators surely, refer to the
procedure included with the optional double
stacking bracket MCO-170PS or the stacking plate
MCO-50SB.
Notes:
• When stacking incubators, fix the upper incubator
to the wall by passing a wire or chain through the
hooks on the back side of the unit to prevent falling
over (Fig. 4).
• When stacking our other CO
incubator with this product (double-stacking or
triple-stacking), the brackets/plates to be used vary
depending on the combination. Refer to table 8,9
on page 86.
Notes:
• When the incubator is not in use
Empty the water from the humidifying pan and remove moisture from the chamber. Make sure that the
chamber is completely dry before closing the doors. Failure to do so may result in damage.
• Before moving the incubator
Before moving the incubator, empty the water from the humidifying pan, disconnect the power supply plug
from the outlet, and make sure that the power supply cord will not be damaged. Failure to do so may result
in electric shock or fire.
18
incubator or O /CO
2 2 2
Hooks
Wire
Fig. 4