Connecting A Co Gas Cylinder - Phcbi MCO-50AIC Instrucciones De Operación

INSTALLATION
Note: Before connecting a CO
Connecting a CO
1. Prepare a CO gas cylinder and attach the optional gas regulator MCO-010R.
2
Notes:
• Use a liquefied-CO
• When MCO-010R is not available, attach a gas regulator rated at 25 MPa(G) (250 kgf/cm
psi(G)) for the primary side, and 0.25 MPa(G) (2.5 kgf/cm
2. Connect the connecting port A for the CO
included gas tube
connection.
Lower right side of unit
Connecting port A for CO
Connecting port for GAS tube
Notes:
• This product employs a tube fitting. Refer to the following steps to attach and remove the tube.
(1) Attaching the tube
Insert the tube all the way to the end so that the tube is secured by the inner locking hook and sealed
with elastic sleeve around it.
* In order to make sure that the tube is securely attached, pull the tube after connection. If the tube
comes off, pull the release ring, and then reconnect the tube and check if it does not become detached.
(2) Removing the tube
Disconnect the tube while pressing on the release ring to remove the tube.
• Connecting to the gas regulator (MCO-010R)
<When connecting to the joint for the gas regulator tube>
(1) Attach the conversion joint that came with the incubator unit to the gas tube.
(2) Connect between the joints using the connection tube, and then secure the connection with the
tube bands.
Gas regulator
Connection tube
Preparation
of parts
(Reference)
gas cylinder, read the precautions for safe operation on pages 5–9.
2
gas cylinder
2
gas cylinder (at least 99.5 % pure). The siphon (dip tube) type cannot be used.
2
When CO gas auto-changer MCO-50GC (optional) is installed, refer to page 67 for the
.
2
2
Tube bands
Connection tube: φ6 inner diameter/soft polyurethane tube
Tube bands
2 (G), 36 psi(G)) for the secondary side.
gas pipe and the gas regulator for the CO
2
gas pipe
Enlarged illustration of the port (tube fitting)
Conversion joint (included accessory)
Gas tube (included accessory)
Release ring
gas cylinder using the
2
Release ring
Push
Pull
2 (G), 3,600
19