Installation - Phcbi MCO-50AIC Instrucciones De Operación

INSTALLATION

Installation
1. Remove the packing tape and clean up.
Remove all the tapes securing the doors and the inner attachments. Open the doors to ventilate the
chamber for a while. If the outer panels are dirty, use a cloth to wipe them with a diluted neutral detergent
(Undiluted detergent can damage the plastic components. For the dilution, refer to the instructions on the
detergent).
Wipe off the residual detergent with a piece of gauze moistened with water and then wipe off any moisture
with a dry cloth.
Note: Remove the cable tie around the power supply cord to prevent corrosion of the cord coating.
2. Set up the humidifying pan (Fig. 1).
Humidifying pan
Fig.1
3. Install 2 trays (Fig. 2).
Note: Position the trays with the front edge bent down.
2 Trays
Fig. 2
4. Adjust the leveling feet.
Adjust the leveling feet by turning them
anticlockwise until the incubator is level (Fig. 3).
Note: Incubating on a sloping tray may adversely
affect the cultivation.
Shrink
Stretch
Leveling feet
Fig. 3
17