Securing Child In Infant Carrier - CYBEX ATON Manual Del Propietário

Securing Child in Infant Carrier

1. Loosen Harness by rmly pressing down
the Harness Adjustment Button (a) while
pulling forward on both straps (b).
2. Press RED button on Harness
Buckle to release Tongues.
3. Separate Chest Clip and spread straps
apart. Place child in Infant Carrier in seated
position making sure their bottom is in the
seat, and their back is fully supported.
4. Pull Harness straps over each arm onto shoulders
and around the hips. Make sure Buckle Pad
and Harness Buckle are between the legs.
Newborns tend to draw arms and legs close to their
bodies. Gently extend each limb to allow for proper
Harness positioning. Be mindful of especially
sensitive areas (e.g. bellybuttons, circumcisions).
5. Buckle by inserting one Tongue at a time into the
Harness Buckle listening for an audible CLICK with
each one. Make sure Harness Straps are not twisted.
MAKE SURE Harness straps are AT or BELOW child's
shoulders. If not, see Adjusting Harness Height, page
13 or the Infant Insert section on page 16.
ALWAYS CHECK Harness Buckle to make sure it is
securely latched. Failure to fasten and tighten the
Harness system correctly with each use can result in
DEATH or SERIOUS INJURY.
6. Connect the Chest Clip listening for an audible CLICK.
14
Using the Infant Carrier
b
a