CYBEX ATON Manual Del Propietário página 29

7. Press the Belt Tensioning Plate down with both
hands, where indicated, until it locks into place.
The ORANGE Locking Lever will rotate to the
CLOSE position when the Plate is locked.
If the Belt Tensioning Plate does not lock, try
loosening the vehicle belt slightly.
8. Grab the Base at the Belt Guides and pull from
side to side and front to back to make sure it is
installed correctly. The Base should not move
more than 1 inch (2,5 cm) in any direction.
If the Base moves too much, open the Belt
Tensioning Plate and remove a little more slack
from the vehicle belt, close Plate and recheck. After
this, if the Base still moves too much, you may need
to try a different vehicle seat or installation method,
or both.
9. Check that the Recline Angle is appropriate for
the child's weight. If not, remove Base, adjust
recline angle and reinstall, see page 36.
10. Make sure that vehicle belt buckle and
hardware DO NOT INTERFERE with correct
installation of the Base, or with the connection
of the Infant Carrier to the Base.
NEVER LEAVE an empty child restraint unsecured in
your vehicle.
BEFORE each use, ALWAYS CHECK that the child
restraint is tightly secured in the vehicle seat.
Installing the Base
PRESS
PRESS
27