Using Vehicle Lap Belt Only - CYBEX ATON Manual Del Propietário

Using Vehicle Lap Belt Only

1. Position Base on a forward facing vehicle seat
with the Leveling Foot toward vehicle seat back.
2. Adjust the Leveling Foot to the correct
angle for your child as shown on the Level
Indicator. See page 36 for more.
3. Fully open Belt Tensioning Plate by turning
the ORANGE Locking Lever to the
position and lifting up on the Plate.
Once open, the Belt Tensioning Plate will remain
open on its own. The Locking Lever should be in the
OPEN position with the Plate open.
4. Route the lap belt under the Belt Tensioning
Plate, and over the Belt Guides on both
sides of the base. Buckle the belt. Make sure
the belts lay at and are not twisted.
In vehicles with longer buckle stalks, the vehicle
belt should ALWAYS be routed UNDER the tab on the
Belt Guide. NEVER place a vehicle belt over the tab
on the Belt Guide.
5. Remove slack from the lap belt. Make sure the
vehicle lap belt is LOCKED. Refer to vehicle
Owner's Manual
At this point, only remove slack from the vehicle
belt. The Belt Tensioning Plate will tighten the
system fully.
6. Tuck the loose end of the lap belt under the base,
so it's out of the way and DOES NOT INTERFERE
with the closing of the Belt Tensioning Plate or
the connection of the Infant Carrier to the Base.
26
Installing the Base
OPEN
for more information.
4–22 lb
22–32 lb
1,8–10 kg
10–14,5 kg