CYBEX ATON Manual Del Propietário página 33

Installing the Infant Carrier without the Base
7. Check the recline angle. Adjust the seat angle
until the RED line on the Infant Carrier is
level with the ground. A tightly rolled towel or
pool noodle may be placed under the Infant
Carrier near the vehicle seat back to adjust the
angle. See page 37 for more information.
8. Grab the Infant Carrier at the Belt Guides and pull
from side to side and front to back to make sure it
is installed correctly. The Infant Carrier should not
move more than 1 inch (2,5 cm) in any direction.
If the Infant Carrier moves too much, tighten the
vehicle belts more and recheck. You may try a
different vehicle seat or installation method, or both.
The Carry Handle MUST be in the CARRY POSITION
when using this child restraint in a vehicle.
NEVER LEAVE an empty child restraint unsecured in
your vehicle.
NEVER INSTALL the Infant Carrier with the lap and
shoulder belts routed underneath BOTH Belt Guides.
Line MUST be level
with ground when
installed without
Base
31