CYBEX ATON Manual Del Propietário página 27

7. Press the Belt Tensioning Plate down with both
hands where indicated, until it locks into place.
The orange Locking Lever will rotate to the
CLOSE position when the Plate is locked.
If Belt Tensioning Plate does not lock, try loosening the
vehicle belt slightly.
8. Grab the Base at the Belt Guides and pull from
side to side and front to back to make sure it is
installed correctly. The Base should not move
more than 1 inch (2,5 cm) in any direction.
If the Base moves too much, open the Belt Tensioning
Plate and remove a little more slack from the vehicle
belt, close Plate and recheck. After this, if the Base still
moves too much, you may need to try a different
vehicle seat or installation method, or both.
9. Check that the Recline Angle is appropriate for
the child's weight. If not, remove Base, adjust
recline angle and reinstall, see page 36.
10. Make sure that vehicle belt buckle and hardware DO
NOT INTERFERE with correct installation of the Base, or
with the connection of the Infant Carrier to the Base.
11. Put vehicle belt in LOCKED mode, see vehicle
Owner's Manual
In most vehicles, you can switch the shoulder belt retractor into locking mode by pulling out
shoulder belt all the way and then letting it rewind into the retractor. Pull on the belt to make
sure it is locking.
NEVER install this child restraint using a non-locking vehicle belt. A locking clip MUST BE used
with a vehicle lap shoulder belt that DOES NOT LOCK. Call the Regal Lager Customer Care
Department at 1.800.593.5522 to obtain a locking clip.
NEVER LEAVE an empty child restraint unsecured in your vehicle.
BEFORE each use, ALWAYS CHECK that the child restraint is tightly secured in the vehicle seat.
Installing the Base
for more information.
PRESS
PRESS
25