Care And Cleaning; Removing The Seat Cover - CYBEX ATON Manual Del Propietário

Removing the Seat Cover

The seat cover is designed to be very taut and to t exactly inside the Infant Carrier. Please pay close
attention before and during the removal of the cover, to help remember how to put it back on.
1. Remove Harness Straps from Harness Slots as described on
page 12. Remove Shoulder and Buckle Pads.
2. Carefully remove the cover from the perimeter of the shell around the Belt
Guides, paying special attention not to damage the EPS foam.
3. Remove the cover from around the plastic Adjustment Strap
Cover and slide it up around the Harness Buckle.
DO NOT damage, remove or dispose of any EPS foam.
NEVER use Infant Carrier without a properly installed Seat Cover.
Installing the Seat Cover
Reverse the removal instructions to reinstall the Seat Cover. Start at the top of the seat and work your
way down to the Belt Guides and foot area.
Pay close attention to reinserting the edge of the Seat Cover into the tight spaces around the Belt
Guides, as well as the foot end of the seat.
38

Care and Cleaning