Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Operating manual - English
7.4
E
LECTRONIC CIRCUIT BOARD REPLACEMENT
Replace the electronic circuit board in the following way:
1) turn off the machine and unplug.
2) remove the bottom panel (Ch. 7.8, page 76).
3) disconnect all the wires from the board.
Fig. 57
4) loosen the nuts (E) and remove the board.
5) fit the new board on the threaded pins and screw down the nuts, re-connect all the wires (each
connector is polarized and cannot be placed in the wrong position).
6) replace the bottom plate and re-position the machine on the workbench.
7) turn on the machine and launch the TRANSFER PROGRAM in order to transmit the software.
8) carry out the calibration operations (Ch. 5.7.4 "Machine Zero Points", page 52 and Ch. 5.6.1
"Automatic calibration of clamp", page 34).
Copyright Silca 2006
TRI-CODE H.S.
E
73
Capítulos
Tabla de contenido
