Fitting The Clamp To The Machine - Silca Tri-Code Manual De Uso

Operating manual - English
4.4 F
ITTING THE CLAMP TO THE MACHINE
To remove the clamp:
- Loosen the (F1) handle by one turn and pull the (F2) anatomic grip towards the operator (front of the
machine). This releases the clamp so that it can slide to the right or left along the dovetail groove and
be removed.
To install the clamp on the machine:
Attention: at initial start-up DO NOT CONTINUE. Zero out the axes and remove the tie wrap (H3) (fig. 25).
Press both the SHIFT + STOP buttons to continue with the zero positioning.
The axes are automatically zeroed out.
First the display shows:
Then it returns to the initial menu.
You can then fit the clamp to the machine (Ch. 4.4, page 18).
Loosen the (F1) handle by at least one turn and pull the anatomic grip (F2) towards the front of the
machine to be able to slide the clamp into the dovetail groove. The clamp has 3 positioning notches that
correspond to the 3 cutting positions on the clamp (Jaw A, B or C).
When the anatomic grip is released and the clamp is manually moved (to the right or left) the positioning
device in the groove will lock the clamp into the first notch it finds. When the clamp is in the required
position (Jaw A, B or C), tighten the (F1) handle.
These instructions refer exclusively to the clamp
Fig. 24
Fig. 25
18
P o s i t i o n i n g
i n p r o g r e s s !
provided.
F2
F1
Copyright Silca 2006
F
H3
TRI-CODE H.S.