Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Operating manual - English
Press ENTER to continue; the display will show the message:
Press START to continue.
The value "Axis 1"appears during cutting of the 1st axis.
Going on to cut axis 2, the following message appears:
When side A has been cut, the following message appears:
Raise the safety shield, loosen the (F) knob remove the key, turn it 180°, replace on the clamp (clamp
A and Stop 2) and lock the (F) knob. Lower the safety shield and press START.
The value "Axis 1"appears during cutting of the 1st axis.
Going on to cut axis 2, the following message appears:
When the operation is complete, the following message appears:
Press [ENTER] to proceed with another copy.
Press [STOP] to end the operation.
•
after terminating the cutting operation and pressing [STOP], a new window appears to ask whether
the user wishes to cut a new key with a different code without repeating the search from the
beginning:
•
[CLEAR] to delete the existing code.
C l a m p : A
P o s . : 2
C u t t e r : H 1 0 1
D i a l : 5
K e y o n s i d e A
P c s : 1 / 1
[ S T A R T ]
C U T T I N G I N P R O G R E S S
C o p y : 1 o f : 1
S i d e : A
A x i s : 1
C U T T I N G I N P R O G R E S S
C o p y : 1 o f : 1
S i d e : A
A x i s : 2
C l a m p : A
P o s . : 2
C u t t e r : H 1 0 1
D i a l : 5
K e y o n s i d e B
[ S T A R T ]
C U T T I N G I N P R O G R E S S
C o p y : 1 o f : 1
S i d e : B
A x i s : 1
C U T T I N G I N P R O G R E S S
C o p y : 1 o f : 1
S i d e : B
A x i s : 2
C o p y : 1 o f : 1
f i n i s h e d !
M o r e c o p i e s ?
N o = S T O P
Y E S = E N T E R
N e w c o d e ?
= K 0 0 1
( K 0 0 1 - N 7 1 8 )
Copyright Silca 2006
[ E N T E R ]
TRI-CODE H.S.
33
Capítulos
Tabla de contenido
