Silca Tri-Code Manual De Uso página 30

Operating manual - English
Press the key (down arrow) and the display will indicate the cuts corresponding to the second axis
(example):
ATTENTION
- press the key [arrow right] to move the pointer (on the same axis) into the various cutting
positions.
- Press the key [arrow up] to eliminate the cuts indicated by the pointer (an empty space is
created); the cutting positions remain unaltered [6].
- Press the key (CLEAR/COPY) to eliminate some cuts (the machine considers consecutive
cuts and not empty spaces) and reduce the cutting positions [5].
Press ENTER to proceed with the cutting operations. The display will show:
Raise the safety shield, loosen the (F) knob and remove the original key. Fit the key blank into the clamp
(clamp A and Stop 2) and lock the (F) knob.
Lower the safety shield.
If the number of keys to be cut is different from 1, use the alphanumerical keys on the keyboard to enter
the number of keys required (pieces) [1-255].
Attention: the operator is responsible for installing the right cutter as there is no electronic device to warn of
any errors!!!
Press START to begin cutting.
A x i s : 2 o f : 2
S i d e s : A B
2 3 4 2 4 2
( 1 2 3 4 5 6 )
C l a m p : A P o s . : 2
C u t t e r : H 1 0 1 D i a l : 5
K e y o n s i d e A
P c s = 1 / 1 [ S TA R T ]
Copyright Silca 2006
[ 6 ]
TRI-CODE H.S.
25