User Adjustments - Silca Tri-Code Manual De Uso

Operating manual - English
5.6.4

User adjustments

By means of the TRI-CODE H.S. program the operator can make manual adjustments by entering
values for the X and Y parameters.
Adjustments to the values for X and Y can be made only for the clamp, as shown in fig. 42.
Fig. 42
• Clamps
The operator can make manual adjustments to the theoretical references or key stop points by entering
values for the X and Y parameters.
This will vary the results of the cutting operation in the way shown in fig. 42.
Select the function from the main menu by placing the cursor on "3 - Calibrations"
Select "1 - Clamps".
Select the clamp (A or B or C).
Place the cursor by the side of the parameter to be altered with the arrows
[ENTER]
SHIFT +
SHIFT +
CLEAR
Press [ENTER] on the last field to quit the window. You will be asked if you want to save the adjustments
made:
Attention: if the [STOP] key is pressed, the new settings will be lost and only the previous values will be valid.
46
-Y
+Y
-X
C l a m p : A
A d j u s t m e n t :
X = + 0 0
To c a l i b r a t e
C l a m p : B
A d j u s t m e n t :
X = + 0 0
To c a l i b r a t e
C l a m p : C
A d j u s t m e n t :
X = + 0 0
To c a l i b r a t e
and alter the parameters using the following keys:
[up arrow] Increases the value within +50 hundredths of a mm (+0.0196")
[down arrow] Decreases the value within - 50 hundredths of a mm (-0.0196")
To zero the value
S a v e a d j u s t m e n t ?
N o = S T O P
Copyright Silca 2006
+X
Y = + 0 0
[ S TA R T ]
Y = + 0 0
[ S TA R T ]
Y = + 0 0
[ S TA R T ]
Ye s = E N T E R
TRI-CODE H.S.
[up/down] or