Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Operating manual - English
P
ROCEED AXIS BY AXIS
Regulation of sensor for top carriage (X axis):
•
lift the protective shield.
•
use the hex wrench to loosen the grub screw (B1) slowly move the rod (B2) manually in both
directions (fig. 51) until the point of transition from OFF to ON is found. The display changes from:
to:
•
secure the rod by tightening the grub screw (B1).
Fig. 51
Regulation of sensor for bottom carriage (Y axis):
•
tip the machine onto one side.
•
Open the lower compartment (Ch. 7.8, page 76).
•
Loosen the screw (L5) and remove the sensor plate (fig. 52, page 56).
•
Loosen the nut (L3) and regulate the Y measurement.
•
Secure the plate by locking the screw (L5) until the display shows a description that goes from OFF
to ON. The display goes from:
to:
•
reposition the machine on its workbench and lower the shield.
•
press the [START] push button.
•
the 'Machine Zero Points' are detected by electric contact.
,
AS FOLLOWS
S e n s o r p o s i t i o n i n g
I C X = O F F
S e e o p e r a t i n g m a n u a l .
S e n s o r p o s i t i o n i n g
I C X = O N
S e e o p e r a t i n g m a n u a l .
B1
B2
S e n s o r p o s i t i o n i n g
I C X = O N
S e e o p e r a t i n g m a n u a l .
S e n s o r p o s i t i o n i n g
I C X = O N
S e e o p e r a t i n g m a n u a l .
Copyright Silca 2006
:
I C Y = O F F
[ S T A R T ]
I C Y = O F F
[ S T A R T ]
X axis sensor
0,1 / 0,4 mm (0.0039" / 0.0157")
I C Y = O F F
[ S T A R T ]
I C Y = O N
[ S T A R T ]
TRI-CODE H.S.
55
Capítulos
Tabla de contenido
