Silca Tri-Code Manual De Uso página 34

Operating manual - English
The value "Axis 1"appears during cutting of the 1st axis.
Going on to cut axis 2, the following message appears:
When side A has been cut, the following message appears:
Raise the safety shield, loosen the (F) knob remove the key, turn it 180°, replace on the clamp (clamp
A and Stop 2) and lock the (F) knob.
Lower the safety shield and press START.
The value "Axis 1"appears during cutting of the 1st axis.
Going on to cut axis 2, the following message appears:
When the operation is complete, the following message appears:
Press [ENTER] to proceed with another copy.
Press [STOP] to end the operation.
C U T T I N G I N P R O G R E S S
C o p y : 1 o f : 1
S i d e : A
A x i s : 1
C U T T I N G I N P R O G R E S S
C o p y : 1 o f : 1
S i d e : A
A x i s : 2
C l a m p : A P o s . : 2
C u t t e r : H 1 0 1 D i a l : 5
K e y o n s i d e B
[ S T A R T ]
C U T T I N G I N P R O G R E S S
C o p y : 1 o f : 1
S i d e : B
A x i s : 1
C U T T I N G I N P R O G R E S S
C o p y : 1 o f : 1
S i d e : B
A x i s : 2
C o p y : 1 o f : 2
f i n i s h e d !
M o r e c o p i e s ?
N o = S T O P Ye s = E N T E R
Copyright Silca 2006
TRI-CODE H.S.
29