Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Operating manual - English
The data on the selected data card do not allow decoding.
The data on the selected data card do not allow code cutting.
Shows that the clamp has been placed in a position different from that required on the display for the
operation in progress (check position of clamp A / B / C)
5.9.2

ALARM messages

The message shows that the clamp required by the program flow for cutting or decoding has not been
calibrated. Calibrate the clamp involved (see example in Ch. 5.6.1, page 34) (position A / B / C)
The message shows that the cutter or tracer has come into contact with an obstacle during its approach
to a position not set. E.g.:
there is a foreign body on the clamp.
the key has not been placed in position properly (vertically instead of horizontally) or does not
correspond to the one required by the SSN selected.
the clamp fitted is different from that required by the processing/decoding in progress (position A /
B / C).
A value exceeding the allowed limit has been detected during cutting.
It is essential to re-gauge.
62
E R R O R 7
K e y c a n n o t b e
d e c o d e d !
E R R O R 8
K e y c a n n o t b e
m a d e !
E R R O R 9
C l a m p
n o t i n s t a l l e d
c o r r e c t l y !
A L A R M 1
C l a m p
n o t c a l i b r a t e d !
A L A R M 2
F a u l t y
c o n t a c t m a d e !
A L A R M 3
D e p t h l i m i t
e x c e e d e d !
Copyright Silca 2006
TRI-CODE H.S.

Capítulos

Tabla de contenido
loading

Productos relacionados para Silca Tri-Code

Tabla de contenido