Attention Messages - Silca Tri-Code Manual De Uso

Operating manual - English
Signals that the lever/handle (N) has not been tightened after changing the position of the graduated
dial. Raise the safety shield and tighten the lever/handle.
This message indicates that there is a fault on the axis referred to (X or Y) due to:
- an obstacle impeding free movement of the axis to complete its run.
- a fault on the limit switch (do the sensor TEST)
- a fault on the motor that moves the axis (do the motor TEST)
- break down of motor control on the electronic board (do the motor TEST).
5.9.3

ATTENTION messages

Signals that the clamp has not been detected for the operation in progress, or that the clamp has not
been positioned correctly on going from one job to another with a different clamp (position A / B C).
Signals that unexpected contact has been made during the operation in progress.
According to the operation, carefully clean the clamp, tracer point/decoder, cutter or template.
Check that the clamp, key or template is in the right position.
Signals that the battery for the date/time function is flat.
Replace the battery (Ch. 7.16, page 82).
Signals that the cutter has exceeded its set duration (Ch. 5.7.1, page 47).
Replace the cutter (Ch. 4.6, page 19)
64
A L A R M 11
D I A L L O C K
C l o s e t h e l e v e r !
A L A R M 1 2
M o v e m e n t a x i s
n o t c o m p l e t e l y
z e r o e d .
A T T E N T I O N
I n s t a l l c l a m p :
A T T E N T I O N
E l i m i n a t e c o n t a c t
b e f o r e p r o c e e d i n g .
A T T E N T I O N
B a t t e r y f l a t
A T T E N T I O N
B l u n t c u t t e r !
R e p l a c e i t ?
N o = S T O P Ye s = E N T E R
Copyright Silca 2006
TRI-CODE H.S.