Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Operating manual - English
3
MACHINE INSTALLATION AND PREPARATION
The key-cutting machine can be installed by the purchaser and does not require any special skills.
It is supplied ready for use and does not need to be set up. However, some checks and preparation for
use have to be carried out by the operator.
3.1
C
HECKING FOR DAMAGE
TRI-CODE H.S. is solid and compact and will not normally damage if transport, unpacking and
installation have all been carried out according to the instructions in this manual. However, it is always
advisable to check that the machine has not suffered any damage.
3.2
E
NVIRONMENTAL CONDITIONS
To ensure that the best use is made of the key-cutting machine, bear in mind the following parameters
for its location: the area should be well-aired and dry.
The ideal conditions for the machine are:
temperature between 10°C and 40°C;
3.3
P
OSITIONING
1) place the machine on a horizontal surface, solid enough to take the weight (43 Kg).
- for comfort when using the working parts of the machine, the workbench should be at the same
height as the operator's hips.
- it is important to leave clearance of at least 30 cm (11.805") behind the machine and on each side
to ensure proper ventilation.
2) ensure that the mains voltage is the same as that of the machine, which must be earthed and
provided with a differential switch.
3) connect the electricity supply wire to the power inlet and the plug (Z) (fig. 4, page 6).
100 cm (39.35")
Fig. 8
30 cm (11.805")
Copyright Silca 2006
relative humidity: approx60%
30 cm (11.805")
30 cm (11.805")
TRI-CODE H.S.
11
Capítulos
Tabla de contenido
