Silca Tri-Code Manual De Uso página 49

Operating manual - English
- Loosen the lever (N) and turn the (O) dial to the left until it reaches position 10 (you should hear it
click into place)
- Loosen the (F1) handle by one turn and pull the anatomic grip (F2) towards the operator. This
releases the clamp so that it can slide to the right. Release the anatomic grip and move the clamp
manually. The positioning device will lock the clamp in the clamp reference notch.
- When the clamp is in position (Clamp A) tighten the (F1) handle.
- Turn the (F) knob to the left. Fit the Z22-B template into jaw A so that it lies flat on the clamp and is
well up against Stop 2 (to do this the Stop 1 plate must be turned left and downwards).
- Secure the Z22 template by turning the (F) knob to the right.
- Move the carriages manually, taking the area marked C on the Z22 template precisely under the
U111DC decoder.
- Turn the (O) dial to the right until it reaches position 6 (you should hear it click into place).
Fig. 40
- Start the key-cutting machine, enter the main menu and position the pointer on "4 - Maintenance".
Press ENTER; the display will show the message:
- position the pointer on "2 - Test" and press ENTER; the display will show:
- position the pointer on "7 – Electric Contact" and press ENTER; the display will show:
44
N
1 - C u t t e r
2 - T e s t
3 - C u t t i n g T e s t
1 - X a x i s m o t o r
2 - Y a x i s m o t o r
3 - C u t t e r m o t o r
4 - X a x i s s e n s o r
5 - Y a x i s s e n s o r
6 - S h i e l d m i c r o
7 - E l e c t r i c c o n t a c t
8 - D i a l l o c k l e v e r
9 - K e y b o a r d
1 0 - D i s p l a y
1 1 - S e r i a l p o r t
1 2 - B a t t e r y s t a t u s
7 E L E C T R I C C O N T A C T
M a k e a c o n t a c t
C U T T E R T R A C E R
S t a t . : O F F S t a t . : O F F
Copyright Silca 2006
O
F2
F1
> >
TRI-CODE H.S.
F