Tabla de contenido
Adjustment
of needle plate setting knob
(Changing
to standard
serging
or rolled
hemming)
•
Turn off the power switch and unplug the machine.
•
Open the looper and side covers.
•
Deactivate the upper knife (refer to page 60).
•
Push the cutting width adjusting dial to right as far as it
will go, then, move the needle plate setting knob to
guide line of S (for Standard Serging) or R (for Rolled
Hemming). Release the cutting width adjusting dial to
the left gently.
•
Set the upper knife to the up position.
•
Close the looper and side covers.
Chaining finger
/._2_ G uide line
(_ Cutting width adjusting dial
_
Needle plate setting knob
L-_ Upper knife
Standard serging
(_ Chaining finger
(_ Needle plate setting knob
Rolled hemming
(1_)Chaining finger
_2")Needle plate setting knob
62
Tabla de contenido
