Tabla de contenido
• Threading the needle on the left
Place the spool of thread on the left side spool pin.
Points to thread for needle on the left are marked in
yellow.
•- A convenient threading chart is placed on the machine
body which is located inside the looper cover,
©
•
Draw the thread through the thread guide on the left
from back to front.
<!J Thread guide
•
Pass the thread through the holes on the left of the
thread guide plate as illustrated.
_) Thread guide plate
•
Hold the thread at both ends and tug gently to ensure the
thread is correctly inserted between the tension discs.
(If the presser foot lifter is raised, the thread easily inserts
between the tension discs.)
<_ Thread tension dial
•
Slide the thread from the bottom of front cover thread
guide (2) and the take-up lever cover from right to left.
•
Guide the thread over the front cover thread guide (3),
•
Insert the thread into the left slot of the guide plate.
•
Raise the needle to its highest point and pass the
thread through the needle bar thread guide from left to
right,
•
Thread the left needle from front to back and pull the
thread about 10 cm (4") from the eye of the needle to
the back under the foot.
Note:
When you pull the needle thread under the
presser foot, be careful not to wind the thread
around the upper looper.
_------------------_
Front cover thread guide (2)
,._ Guide plate
Take-up lever cover
_'j Needle bar thread guide
'_ Front cover thread guide (3)
"9_Left needle
_?
J
34
Tabla de contenido
