Description Of The Symbols; Important; Machine Composition; Prearrangements At Purchaser'scharge - OEM SUPER TOP Manual De Uso

SUPER TOP
General specifications and warning

1.3 - DESCRIPTION OF THE SYMBOLS

Many accidents are caused by a poor knowledge of
and by a non compliance with the safety regulations
to put into practice during the functioning and main-
tenance works to be done on the machine.
In order to avoid any accidents, read understand
and follow all the warnings and cautions contained
in this booklet and those written on the plates located
on the machine.
To identify the safety messages included in this book-
let, following symbols have been used:
DANGER
This symbol is used in the safety messages
contained in the booklet in case of potential
danger situations or possibility to cause
serious injuries or dead.
ATTENTION
This symbol is used in the safety messages
of the booklet for any danger situation that,
if disregarded, may cause small or moder-
ate injuries or damages.
The message can be used also in case of
danger situations that may cause damages
to the machine.

IMPORTANT

This symbol is used in case of precaution-
ary measures to be taken in order to avoid
any operation that may reduce the life of the
machine or for important communication to
the operator.
DANGER
For clarity reasons, some illustrations of
this booklet show the machine without
safety guards. DO NOT USE THE MACHINE
WITHOUT SAFETY GUARDS.

1.4 - MACHINE COMPOSITION

Manufacturer's machines are the results of a consider-
able experience.
• Ovens can be fitted with one single, two or three
chambers, digitally operated.
• A richiesta può essere fornito un kit di aspirazione
If requested by a customer, a smoke extracting kit
can be positioned on the rear or upper side of the
oven and can be controlled by operating the control
board of the oven.
• The oven/s is/are placed on a bearing base equipped
with wheels.
1.5 - PREARRANGEMENTS AT PURCHASER'S
CHARGE
a) Prearrangement of the installation place.
• The purchaser shall prearrange a supporting surface
for the machine as indicated in the chapter "Installa-
tion".
b) Electric prearrangement.
• The power system should comply with the local
regulations and provided with an efficient earthing.
• Place an omnipolar sectioning device on the power
feed line, above the machine.
• The size of the electric power cables should
comply with the maximum current required by
the machine, so that the total voltage drop at
full charge will be less than 2%.
c) Flue prearrangement
• It is necessary to prearrange a vapour flue, whose
features shall be in compliance with the rules being
in force in the Country the oven shall be installed in.
b) Neutral wire
• The machine is equipped with neutral wire, therefore,
a special terminal being identified according to the
relevant directions has been prearranged.
EN - 5