Corghi CompactLine Serie Manual De Uso página 104

ured during the last spin performed which must therefore refer to the wheel being serviced.
Proceed as follows to recall this programme:
- Select the OPT Flash icon
OPT STEP 1
1. take the valve to 12 o'clock;
2. press Enter
OPT STEP 2
3. turn the wheel until the valve gets to 6 o'clock position (the bottom arrow turns from
red to green);
4. make a chalk mark on the tyre external side at 12 o'clock;
5. confirm you marked the tyre by selecting Enter
6. remove the wheel from the wheel balancer;
7. turn the tyre on the rim until the mark made matches the valve (180º rotation);
8. refit the wheel on the wheel balancer and confirm the operation described in points
6 and 7 by selecting enter
Then, following the new indications on the monitor:
9. turn the wheel until the valve gets to 12 o'clock position:
10. press the Enter button
11. perform a spin.
Now, the real unbalance values of the wheel thus mounted on the wheel balancer are dis-
played. Take the wheel to the position shown on the monitor. The foreseen unbalances are
displayed by performing the matching and the proportional improvement which can be
obtained if the user decides to continue the optimisation procedure.
In case optimising is insufficient, or significant improvements cannot be obtained, select the
Exit key twice (first to exit the procedure and restart the menu, and then to exit
the programme permanently); perform a spin to balance the wheel; otherwise, the system
goes to the third and final programme phase.
OPT PHASE 3
Following the indications on the monitor:
12. turn the wheel up to the position shown on the position indicator;
13. make a double mark on the outer side of the tyre at the 12 o'clock position with a
piece of chalk. If the screen indicates that the tyre should be switched around on the
rim, make a double mark on the inner side using a piece of chalk.
104
to confirm the operation;
;
to confirm the execution;
Operator's manual EM 9280 - EM 9280 C CompactLine
;