Corghi CompactLine Serie Manual De Uso página 89

DETECTION PLANS BY POINTER LASERBLADE
The detection of the geometrical data relative to the real
balancing planes for the application of adhesive weights,
can be facilitated by the laser line on the lever of the au-
tomatic detector.
To enable this line it is necessary to press the button on
the automatic arm (A, Fig. 12a).
The laser line is thus visible inside the rim for 10 seconds,
after which, if necessary, the button on the automatic arm
must be pressed again.
Wheel data entry for wheel balancers with width measuring
To enter the distance, diameter and width values automatically, proceed as follows:
- bring the automatic internal measuring arm (A, Fig. 10) into contact with the inner
side of the rim as shown in Fig. 12 and at the same time bring the automatic external
measuring arm (B1, Fig. 10) into contact with the outer side (Fig. 13a).
Take great care to position the arm correctly so as to ensure accurate data reading.
- Keep the arms in contact with the rim until the machine has acquired the values.
- Return the arms to their rest position.
- During the spin screen displays the geometric data of distance, diameter and width.
- If an incorrect value has been acquired during the measurement phase, move the arms
to the rest position and then repeat the operation.
Measurements can be taken also by moving one measuring arm at a time. In this case,
sensors can be used with no pre-set order. Pay maximum attention to the measured
data since they are influenced by the stored ones.
After setting geometric dimensions correctly and returning the sensors to the rest posi-
Operator's manual EM 9280 - EM 9280 C CompactLine
(if present)
sensor (if installed)
12
12a
UK
13A
89